Reconstruct a Formidable Back

An essential component of back training is considering movements on both the vertical and horizontal planes. They dictate the motion path and the manner in which force affects our back muscles.

The type of grip plays a significant role when it comes to the pressure exerted on the muscles. And in this case, knowledge of anatomy is extremely important. But before we concentrate on specific muscles, it is important to consider how the elbows move away (outside) or near (inside) relative to the chest. There are three important aspects to consider: – the line of the forearm and wrist must always be straight; – the shoulder girdle should be slightly lowered; – the shoulder blades should be fully engaged, starting from the tension phase to the maximum extension of the movement. Compliance with these aspects ensures safe and correct execution of the exercise, without placing undue pressure on the supporting muscles. It is also important to consider the following aspects: – the overhand grip only occurs when the grip is wider than the shoulder width and at chest height; – the underhand grip is performed up to the chest line, where the range of motion can be deepened, but the grip should not be wider than the shoulder width; – the neutral grip, also known as the hammer grip, is performed up to the chest line, from the lower chest area to the section below the chest; the width can vary from a very narrowly held triangular block to the shoulder width. Training with consideration of these rules allows for the maximum movement, starting from deep pulling/drawing of the weight to stretching the back muscles at the maximum level.

Effective training of the back muscles also requires proper weight management, allowing us to influence the largest muscles of the spine, such as the quadrilateral and the broadest muscles. Knowledge of anatomy and the ability to control the weight are crucial here, as well as muscle tension control. Movements performed at the level of the quadrilateral muscle with a wide grip and a neutral grip (naturally flat) enable more intense engagement of this muscle. Movements performed below the chest line, closer to the body, with a neutral grip and underhand grip (naturally deeper), direct the weight onto the broadest muscle, promoting its growth.

Attempt to isolate the work of the spine extensor. In multistage exercises, which require strong stabilization, there is often a "rupture of the silhouette". Exiting the movement of the extensor first, and then extending the knees causes the work of the back muscles to be significantly limited. How to avoid this? A key role is played here by stabilizing the posture through the involvement of deep muscles. Pulling in the stomach (pulling the navel towards the spine) allows for the isolation of the movements of the extensor, which forces the independent work of the back muscles. Additionally, the basic function of deep muscles is fulfilled, i.e., maintaining the correct position of the lower back. It is also necessary to activate the work of the shoulder blades by setting and lowering the position of the shoulders and strongly pulling the shoulder blades together as well as pulling the weight towards the torso.

The movement that draws the elbow towards the inner side not only strongly activates our pelvic floor muscles (which naturally serve to facilitate arm movement), but also enables the opening of the chest cavity and increasing the range of motion, while also safeguarding the shoulder girdle from potential damage.

If you have the opportunity, follow this rule. Movements such as shifting the load during rowing or dead pulling or free hanging during the execution of pull-ups on the bar, if they last longer than 3 seconds, will force the body to restart movement from the beginning point, which requires the activation of all muscle fibers and the acceleration of the weight. In this way, all motor units will be stimulated to work, and the nervous system will be greatly fatigued. When it comes to the bar, the dead phase will occur during the free hanging with a few seconds of holding, and when it comes to rowing, I recommend applying the Pendley row method.

Strive to provide muscles with a variety of developmental stimuli: strength, based on a low frequency range (15) and the use of a submaximum weight of up to 90% CM; endurance, with a higher frequency than strength, and a decrease in the percentage of our CM 6080%; caused by a long time under tension – over 60 seconds. Work at full muscle tension.. In summary, all the tips contained in this article aimed to show how to train consciously.

I regret to inform you, but this is an unparalleled circumstance for me.